+971 56 978 6395 info@brandingblitz.com

Fabric Exhibition Pop Up Sizes for Dubai Booth Footprints

Fabric Exhibition Pop Up Sizes for Dubai Booth Footprints

Which fabric pop up width fits a 3 by 3 shell scheme, when a curved frame beats a straight one, how much the case weighs and how to set up the artwork.

In this guide
  1. What a fabric exhibition pop up actually is
  2. Fabric exhibition pop up sizes against Dubai booth footprints
  3. Straight or curved: a footprint decision
  4. Standard or backlit
  5. What the case weighs and how it travels
  6. Artwork setup for a fabric exhibition pop up
  7. Building the rest of the stand around it
  8. Prices and timing

Every season we get the same message a week before a show: a photo of a 3 by 3 m shell scheme booth, and the question of what size fabric exhibition pop up will fill the back wall without blocking the walkway. The answer depends on the booth footprint more than on the product, so this guide starts with the booth and works backwards. We print and assemble the frames in Ajman and deliver to Dubai World Trade Centre, Expo City, ADNEC and the Sharjah Expo Centre, usually the day before build up.

What a fabric exhibition pop up actually is

The system is a folding aluminium lattice that expands like an accordion, with a single printed stretch polyester skin zipped over the whole frame. There are no panels, no magnetic strips and no seams through the artwork. The skin goes on once and stays on, so the frame travels fully dressed in a wheeled case and pops open in two or three minutes. The fabric is washable at 30 degrees, which matters after a dusty outdoor activation in Al Ain.

A fabric exhibition pop up comes in four variants on the same frame: straight or curved, each either standard or backlit. The dimensions below apply to all four, and the choice between them is mostly a question of footprint and power.

Fabric exhibition pop up sizes against Dubai booth footprints

Shell scheme walls at Dubai venues are usually 2.5 m high with a 10 cm fascia, and exhibitors are asked to keep graphics 5 cm clear of the panels. That leaves a usable back wall of about 2.3 m high. Here is how the standard pop up widths fit.

Booth footprintRecommended pop upGraphic sizeFloor depth needed
3 by 3 m shell scheme3 by 2.3 m straight3,000 by 2,250 mm35 cm
3 by 3 m, wide aisle3 by 2.3 m curved3,000 by 2,250 mm face70 cm
6 by 3 m inline4.5 by 2.3 m straight plus counter4,500 by 2,250 mm35 cm
6 by 3 m corner3 m straight on each open sideTwo at 3,000 by 2,250 mm35 cm each
Island 6 by 6 mTwo 4.5 m backlit, back to backTwo at 4,500 by 2,250 mm90 cm total

For a standard 3 by 3 booth the straight 3 m fabric pop up is the default fabric exhibition pop up, because it leaves 2.65 m of depth for a counter, a chair and two people. The curved version looks richer but eats 70 cm of floor, which in a 3 by 3 is the difference between a booth you can stand in and one you cannot.

Straight or curved: a footprint decision

A straight fabric pop up display gives a flat graphic that photographs well and fits flush to a shell wall. A curved pop up wraps around the viewer slightly, hides the shell panels at the sides and feels more enclosed. Pick the curved pop up when the booth is 4 m deep or more, when there is no counter, or when the stand is on a corner where the curve meets the aisle. Pick straight when the booth is 3 m deep, when you need to hang a screen on the wall, or when the graphic has a wide landscape image that a curve would distort.

One practical point on a tension fabric display: the curve is set by the frame, not the fabric, so the same skin cannot move between a straight and a curved frame. Decide before printing.

Need fabric pop ups priced for your quantity?

Standard or backlit

The standard fabric exhibition pop up relies on hall lighting, which at DWTC is bright and fairly flat. The backlit fabric pop up adds LED strips inside the frame and a second, lighter fabric on the back as a diffuser, so the whole graphic glows. In the big halls a backlit fabric pop up is visible from the end of the aisle. In a dim hotel ballroom it is the only thing that makes the colours read at all.

A backlit fabric pop up adds about 6 kg to a 3 m frame, needs one socket, and costs roughly 60 percent more than the standard version. It also changes artwork: colours print denser, and large white areas look brilliant. If you are unsure, the backlit backdrop page shows the lit version next to the standard one at the same width. The pop up display page shows the full set of straight frames.

Backlit Backdrop
Backlit BackdropSizes, materials and quantity pricing for backlit backdrop, printed in house and delivered across the UAE. View product

What the case weighs and how it travels

A 3 by 2.3 m straight fabric exhibition pop up weighs about 12 kg in its wheeled case, which is 90 by 40 by 40 cm and goes in the boot of a saloon car. The 4.5 m version is around 18 kg. Backlit adds 6 to 9 kg and a second small case for the LED bars. Nothing needs a van, which is the whole point for a two person team driving from Dubai to ADNEC. Many clients pack a roll up banner or two in the same car for the aisle corners. A folding promotion table for the front fits as well.

Rollup Banners
Rollup BannersSizes, materials and quantity pricing for rollup banners, printed in house and delivered across the UAE. View product

Artwork setup for a fabric exhibition pop up

Fabric prints are forgiving on resolution but strict on layout. Here is the checklist we send to designers.

Rich black should be 60 cyan, 40 magenta, 40 yellow, 100 black. Pure 100 black alone prints as a dark grey on polyester.

Building the rest of the stand around it

A fabric exhibition pop up on its own is a backdrop, not a booth. The additions that matter are a branded counter in front, a totem or lit tower at the aisle corner and a reading surface for brochures. Our exhibition counters are printed from the same artwork so colours match. A totem display stand pulls visitors in from a distance the back wall cannot reach. For a stand that will travel to four or five shows a year, the panels of a modular backlit booth can be reconfigured each time, whereas a tension fabric display is fixed at one width.

Exhibition Counters
Exhibition CountersSizes, materials and quantity pricing for exhibition counters, printed in house and delivered across the UAE. View product

If the budget allows a screen, hang it on a straight fabric pop up display only and keep the graphic behind it dark so the screen edge disappears. A 55 inch screen needs a frame bracket we fit at the factory, so mention it when ordering.

Prices and timing

A 3 m straight fabric pop up display with frame, printed skin and wheeled case costs AED 2,400 to 3,200. The curved version is AED 2,800 to 3,600. Backlit versions run AED 4,200 to 5,800. A replacement skin for a frame you already own is AED 650 to 950, and for a tension fabric display that is the real saving, because the frame outlives several campaigns. Production of any fabric exhibition pop up is four working days from proof approval, three if the show is close and you tell us. The whole range, with current prices by size, sits on our fabric pop ups page. The booth extras are under exhibition booths.

Send us the booth plan from the organiser, the stand number and your logo, and we will reply on WhatsApp with the right width, a mockup inside your footprint and a quote.

Ready to get started?

Look, we have been in this business long enough to know what works and what doesn't. If you are not sure where to begin, just give us a call. No pressure, no sales pitch. We will walk you through the options and give you an honest quote.

What you get with us:

  • Straight answers about what you actually need (not what costs most)
  • Fair pricing. We will tell you how to save money where it makes sense
  • Quick turnaround when you need it, or save by planning ahead

Need Fabric Pop Ups in the UAE?

Our team produces fabric pop ups and related print for businesses across Dubai, Abu Dhabi, Sharjah and every emirate. Send us your brief for a same day quote.

Get Your Free Quote

+971 56 978 6395

AN

Atiya Naaz

Marketing Head, Branding Blitz

Atiya brings five years of hands on experience in the UAE printing and branding industry. Based in Abu Dhabi, she leads marketing team at Branding Blitz, helping businesses across Dubai, Abu Dhabi, Sharjah, and all emirates find right print solutions for their branding needs. Her expertise spans corporate identity materials, exhibition printing, packaging design, and digital marketing strategy for the regional market.

Related resources: See our backdrops, events & exhibitions and exhibition booths pages for specifications, quantity pricing and design options across the UAE.

Frequently Asked Questions

What size fabric exhibition pop up fits a 3 by 3 m shell scheme booth?
Can the same fabric skin be used on a straight and a curved frame?
How much does a backlit fabric pop up weigh and what power does it need?
How should artwork be prepared for a fabric pop up display?
+971 56 978 6395 info@brandingblitz.com Quick Enquiry Get Instant Quote
Follow Us